KOHLER: Whirlpools & Baths: Cast Iron: Care and Cleaning: Tech Info

Categories & Service Parts

Commercial

Resources


	Rinse thoroughly and use a soft cloth to wipe the product dry after each use. In the rare occurrence of stubborn stains, use abrasive cleaners sparingly, but not on Safeguard slip-resistant surface. Use a soft nylon brush on the bath bottom’s Safeguard surface. Do not use steel wool, wire brushes or abrasive sponge pads.
	How to flush a KOHLER whirlpool system.

Comet Bathroom Cleaner

Formula 409 Antibacterial All Purpose

Lysol Bathroom Cleaner

Tilex Soap Scum Remover

Windex Original

Safeguard® Slip-Resistant Surface:
RogIII Tub and Tile Cleaner
(Not sold commercially. Call 1-800-470-8337 to order.)

For rust removal:

Bon Ami

Super Iron Out Multi-Purpose Rust Stain Remover

Zud Multi-Purpose Cream Cleanser


	Wipe out bath/whirlpool after each use with soft cloth or squeegee. Use a mild detergent (such as dish washing soap). Do not use abrasive cleaners. Avoid using aerosol products on the bath surface.
	How to flush a KOHLER whirlpool system.

Lysol Bathroom Cleaner

Tilex Soap Scum Remover

For rust removal:

Super Iron Out Multi-Purpose Rust Stain Remover

Cleaning instructions listed pertain only to their corresponding material, and are not intended for faucet cleaning. Faucet cleaning instructions for chrome and vitreous china.

Success with cleaners and procedures is dependent upon such factors as the hardness and temperature of the water, using exact quantities of ingredients, changes in cleaning formulas and the condition of the product being cleaned. Since there are variations within these factors, Kohler cannot guarantee the effectiveness of the formulas mentioned.

Cream-based cleaners may have a tendency to build up, reducing the friction on slip-resistant surfaces.
Be sure to use a water soluble cleaner (dissolves 100% in water).

To restore dull or scratched units: Apply white automotive polishing compound with a clean cloth. Rub scratches and dull areas vigorously. Wipe off residue. Follow with a coat of white automotive paste wax.
Do not wax areas where you walk or stand. Damaged surfaces can be repaired. Check the Yellow Pages under “Fiberglass-Repair.”