Flush your BodySpa system twice a month or more, depending upon usage.

Fill the footbath with hot water to a level 2" above the suction cover.
Add 2 teaspoons of a low-foaming, powder automatic dishwasher detergent and 4 ounces of household bleach (5% to 6% sodium hypochlorite) to the water.
Run the BodySpa jets and waterfall for 5 to 10 minutes each. Then shut off the BodySpa and drain the water.
Fill the footbath with cold water to a level 2" above the suction cover, and run the BodySpa jets and waterfall for another 5 to 10 minutes each. Drain the footbath and wipe it dry with a soft cloth.

Flush your whirlpool system twice a month or more, depending upon usage.

Adjust the jets fully clockwise so there is no air induction.
Fill the bath with warm water to a level 2" above the highest jets, or leave water in the bath after using.
Add 2 teaspoons of a low-foaming, powder automatic dishwasher detergent and 20 ounces of household bleach (5% to 6% sodium hypochlorite) to the water.
Run the whirlpool for 5 to 10 minutes. Then shut off the whirlpool and drain the water.
If desired, rinse bath surfaces with water.
Clean bath surfaces as needed with recommended cleaners.

Cleaning instructions listed pertain only to their corresponding material, and are not intended for faucet cleaning. Faucet cleaning instructions for chrome and vitreous china.

Success with cleaners and procedures is dependent upon such factors as the hardness and temperature of the water, using exact quantities of ingredients, changes in cleaning formulas and the condition of the product being cleaned. Since there are variations within these factors, Kohler cannot guarantee the effectiveness of the formulas mentioned.